Canon Ir2017 Download Standby

I have connected it to a single PC (XP) with the USB cable and used the CD that came with the machine for the driver installation and it gives the message Download Connected or Download Connected 7701 but the Canon driver installation sofware fails when it tries to connect to the print.

Thanks again and again. I think you are right and this is the way how to clear that, but the buton for additional menu don`t reacting at all. All butons are not responding. Canon Copier Pc 775 Manual Treadmill. I had tryed to push the additional functions then 2 and 8 then aditional functions and nothing and still have on a display massege 'download conected' if the USB cable is conected to the copier and 'download standby' when the USB cable is disconected from the copier! THANK YOU again for the help>just you have any idea for that thank you!!!

(The copier is almost new ). Download Standby Message: iR1022 Series Approved The iR displays 'Download / Standby' Mode at Power On. The iR functions cannot be accessed through the Control Panel.

Cause Corrupt System Software Defective DDR Module Action In one case, flashing the iR to the most current system software, resolved the issue. In another instance, replacement of the DDR module solved the Download Standby Message. The part number for the DDR Module PCB Assembly is as follows: iR1018 / iR1022: FM2-4897-000 iR1022iF: FM2-4898-000 http://www.service.canon.com.au/icons/ecblank.gif. The Machine Boots into Download Mode: iR2020 Series Approved When the machine first boots up, it goes directly into Download Mode. Cause This will happen when the machine does not read the BootROM properly, or the BootROM is blank. Action If this should happen while you boot the machine, connect your laptop and use Service Support Tool Version 3.22e or later to flash the BootROM of this device with at least version 60.02.

Once this is done, the machine will completely boot. Just an update to this fault: I had to run up 7 of these iR1022if for the one customer this week. Out of the 7 the very last machine,at power on,displayed the 'DOWNLOAD STANDBY' message on the screen and you could not clear it.effectively the machine was waiting for a software upgrade. I connected the machine to the tech pc in the workshop and flashed the software using the BATCH ALL 32MB batchfile in SST. No good:mad: Then I realized that this error only occured AFTER I fitted the 32mb print rom to the machine. I retraced my steps and lo-and behold found a cable unplugged on the fax board. Hp Data Protector Express Keygen Free on this page. plugged it in and all was working fine.